Table of Contents
Advertisement
If engine fails to start promptly, do not crank for an extended time. Should engine
fail to start again, allow starter to cool off for 2-3 minutes. If engine fails after
several attempts, refer to engine maintenance manual.
Note: Diesel engines only: After turning on ignition power, operator must
wait until glow plug indicator light goes out before cranking engine.
1.
Turn key of Platform/Ground Select switch to Ground.
2.
Pull the Power/Emergency Stop switch to On.
3.
Push the Engine Start switch until engine starts.
Allow engine to warm-up for a few minutes at low speed before applying any load.
4.
After engine has had sufficient time to warm up, push in the Power/
Emergency Stop switch and shut engine off.
5.
Turn Platform/Ground Select switch to Platform.
6.
From Ground Control Console, pull Power/ Emergency Stop switch out.
800S, 860SJ
CAUTION
CAUTION
31222372
Machine Operation
63
Advertisement
Table of Contents
