Function Check - JLG RT3394 Operation & Safety Manual

6. Oscillating Axle and Oscillation Cylinders – See Inspection Note.
7. Scissor Arms, Centering Link and Sliding Wear Pads – See Inspection Note.
8. Fuel Tank – See Inspection Note.
9. Main Control Valve – No unsupported wires or hoses; no damaged or broken
wires.
10. Leveling Jack Valve (If Equipped) – No unsupported wires or hoses; no
damaged or broken wires.
11. Ground Controls – Placard secure and legible, control switches return to neutral
position when activated and released, emergency stop switch functions properly.
Control markings legible.
12. Drive Valve – No unsupported wires or hoses; no damaged or broken wires.
13. Hydraulic Reservoir – Recommended hydraulic fluid level on level indicator on
tank. Breather cap secure and working.
14. Engine and Hydraulic Pump Assembly – See Inspection Note.
15. Battery Cables/Routing Installation – See Inspection Note.
16. Front Leveling Jack Assembly (If Equipped) – See Inspection Note.
17. Rear Leveling Jack Assembly (If Equipped) – See Inspection Note.
18. Rotary Angle (Elevation) Sensor (located on lower arm attach link pin) – See
Inspection Note.
19. Lift Cylinder – See Inspection Note.
20. Arm Stack Tilt Sensor (on scissor arm cross-member) – See Inspection Note.
21. Safety Prop (on scissor arms) (not shown) – See Inspection Note.
22. Platform Control Console (on platform rail) – Placard secure and legible, control
lever and switches return to neutral when activated and released, all switch
guards are in place, trigger switch and emergency stop switch function properly,
Operation & Safety manual in storage box.
23. Platform/Handrail Installation (not shown) – See Inspection Note.
24. Platform Extension Stops and Rollers (not shown) - Extension stops secure and
undamaged. Rollers are undamaged, free of debris and operate properly.
2.5

FUNCTION CHECK

Perform the Function Check as follows:
RT3394, RT4394
User Responsibilities, Machine Preparation, and Inspection
31221544
31