Radio Frequency (Rf) Information - JLG RT3394 Operation & Safety Manual

3. The tightening of the nuts should be done in stages. Following the recommended
sequence, tighten nuts per wheel torque chart.
4. Wheel nuts should be torqued after first 50 hours of operation and after each
wheel removal. Check torque every 3 months or 150 hours of operation.
1st Stage
85 ft. lb. (115 Nm)

6.10 RADIO FREQUENCY (RF) INFORMATION

Note: The ClearSky® CS550 connectivity module antenna is internal to the assembly.
6.10.1 Federal Communications Commission (FCC)
FCC Interference Statement
ClearSky CS550 has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Notice Regarding Radio Frequency Radiation Exposure
ClearSky CS550 complies with the FCC radio frequency exposure limits prescribed for
mobile use (i. e,. antennas are greater than 20 cm from a person's body) in an
uncontrolled environment. Consequently, a person within 20 cm (8 in) of a CS550 that is
connected to machine battery power could expose that person to RF energy in excess
of what has been established by the FCC RF exposure guidelines.
RT3394, RT4394
General Specifications and Operator Maintenance
Table 6. Wheel Torque Chart
TORQUE SEQUENCE
2nd Stage
110 ft. lb. (149 Nm)
31221544
3rd Stage
170 ft. lb. (230 Nm)
109