JLG RT3394 Operation & Safety Manual page 99

3. Lift the actuator rod (flat) up out of the slot in the keeper plate bracket and pull
the actuator rod to align the safety props vertically with the scissor arm center
pins above and below the safety prop mounting pins.
4. Set the actuator rod (flat at the set position) into the slot on the keeper plate
bracket and rotate the keeper plate to lock the actuator rod in this position.
5. Lower the platform arms until the safety prop rests on the scissor arm center pin
mounts above and below the safety prop.
Maintenance can now begin.
1. Actuator Rod/Rod Keeper Plate.
2. Safety Prop in set position.
To store the safety prop, raise the platform, release the actuator rod from the keeper
plate bracket, push the safety prop rod so that the safety props are restored back to its
stowed position. Lock the actuator rod in place with the rod keeper plate till next use.
RT3394, RT4394
General Specifications and Operator Maintenance
3. Safety Prop in stowed position.
31221544
99