Skysense - JLG RT3394 Operation & Safety Manual

5.8 SKYSENSE®
5.8.1 General Information
SkySense is not intended to replace or reduce the need for the operator to be
aware of the environment around the machine. hazards that will cause serious
injury or death may not be prevented or reduced by SkySense. The operator must
always look in the direction of travel, avoid power lines, avoid obstacles that could
strike the machine or persons in the platform, and follow all instructions on
machine placards and in this manual.
The operator must not rely on SkySense as a substitute for following the
instructions and warnings on machine placards and in this manual.
Read and understand these instructions in their entirety before operating the
machine.
SkySense is intended to assist the operator. SkySense may not detect certain
objects depending on shape, type of material, or orientation of the object to the
sensors. It is the operator's responsibility to be aware of their surroundings at all
times.
Note: SkySense is not active when operating the machine from the ground controls.
5.8.2 Preparation and Inspection
Pre-Operation Inspection:
1. Inspect each of the SkySense tubes for dents, cracks, or other damage.
2. Inspect each Skysense sensor for any damage to the housing or sensor.
To test the system:
1. Ensure there are no obstructions within 10 feet around or above the platform and
the machine is on a smooth, firm surface within the limits of the maximum
operating slope.
2. From the platform control console, lift and lower the platform.
RT3394, RT4394
WARNING
NOTICE
NOTICE
31221544
Accessories
81