JLG RT3394 Operation & Safety Manual page 47

Note: After initial ground contact is made, the auto level function will pause 2-5 seconds and then begin to
properly level the machine.
Note: There is an override feature on the Auto Leveling system that allows the operator to adjust (trim) the
level of the machine to the left or right when the platform is completely lowered. Use the following
instructions to adjust the level of the machine.
1. With the leveling jack switch activated, squeeze the trigger switch on the controller.
2. To adjust the leveling jacks to the left, activate the switch on top of the controller to
the left. To adjust to the right, activate the switch on top of the controller to the right.
The leveling jack indicator light for the side selected will be lit.
Low Fuel Indicator - This light will be illuminated when the fuel remaining in the fuel tank
is getting low.
Overload Indicator (LSS) - Indicates the platform has been overloaded. An audible alarm
will also signal when the platform is overloaded.
Note: If the Overload Indicator is activated while elevated above 14 ft (4.26 m), all
functions will be prevented from the platform and ground controls. Reduce the
weight in the platform to not exceed the rated workload indicated on the ca-
pacity decal, then the controls will work again.
Propane Fuel Select - In this position the switch is set up to change from gasoline to
propane on a machine equipped with the dual fuel option.
Steer Switch/Leveling Trim Adjust - The steer switch/auto leveling trim adjust is located at
the top of the control handle. Selecting the drive function then depressing the switch to the
right will steer the wheels to the right. Depressing the switch to the left will steer the wheels
to the left.
When auto leveling is selected this switch is used to manually adjust (trim) the leveling of the
machine to the left or right. Refer to Manual Level Adjustment (Trim) for operating
procedures.
System Fault Indicator - This warning light will flash the appropriate distress code (flash
code).
RT3394, RT4394
Machine Controls, Indicators, and Operation
31221544
47