Table of Contents
Advertisement
Safety Precautions
•
The MAD may be reduced if insulating barriers are installed to prevent contact, and
the barriers are rated for the voltage of the line being guarded. These barriers shall
not be part of (or attached to) the machine.
•
The MAD shall be reduced to a distance within the designed working dimensions of
the insulating barrier. This determination shall be made by a qualified person with
respect to electrical transmission and distribution in accordance with the employer,
local, or governmental requirements for work practices near energized equipment.
Do not maneuver machine or personnel inside prohibited zone (MAD). Assume all
electrical parts and wiring are energized unless known otherwise.
1.3.4
Tipping Hazards
•
Ensure that the ground conditions are adequate to support the maximum tire load
indicated on the tire load decals located on the chassis adjacent to each wheel. Do
not travel on unsupported surfaces.
•
The user must be familiar with the operating surface before driving. Do not exceed
the allowable side slope and grade while driving.
•
Do not elevate platform or drive with platform elevated while on or near a sloping,
uneven, or soft surface.
•
Ensure machine is positioned on a smooth, firm surface within the limits of the
maximum operating slope before elevating platform or driving with the platform in
the elevated position.
•
Before driving on floors, bridges, trucks, and other surfaces, check allowable capacity
of the surfaces.
•
Never exceed the maximum platform capacity as specified on the platform. Keep all
loads within the confines of the platform, unless authorized by JLG.
•
Keep the chassis of the machine a minimum of 2 ft (0.6m) from holes, bumps, drop-
offs, obstructions, debris, concealed holes, and other potential hazards at the ground
level.
18
DANGER
31221544
RT3394, RT4394
Advertisement
Table of Contents
