Table of Contents
Advertisement
SECTION 2 - USER RESPONSIBILITIES, MACHINE PREPARATION, AND INSPECTION
Function Check
Perform the Function Check as follows:
1.
From the ground control console with no load in the plat-
form:
a. Ensure that all machine functions are disabled when
the Emergency Stop Button is pushed in.
b. Ensure all functions stop when the function switch is
released.
c. Operate all functions and check all limiting and cut-out
switches to ensure proper operation.
d. Check auxiliary power and ensure proper operation.
2.
From the platform control console:
a. Ensure the control console is firmly secured in the
proper location.
b. Check all guards protecting the switches or locks are in
place.
c. Ensure all machine functions are disabled when the
Emergency Stop Button is pushed in.
d. Ensure all machine functions stop when the footswitch
is released.
e. Operate all functions and check all limiting and cut-out
switches to ensure proper operation.
2-10
3.
With the platform in the stowed position:
a. Drive the machine on a grade, not to exceed the rated
gradeability, and stop to ensure the brakes hold.
b. Check that the tilt indicator is illuminated to ensure
proper operation.
4.
Swing the boom over either rear corner of the machine and
ensure that the Drive Orientation indicator illuminates and
that the Drive Orientation Override switch must be used for
the drive function to operate.
5.
With the machine positioned on a smooth, firm surface
within the limits of the maximum operating slope, elevate
the boom above 5 degrees of horizontal or extend beyond
1.6 feet (0.5 m). Select high speed drive mode. Carefully
attempt to drive and ensure the drive speed is reduced.
31215018
Advertisement
Table of Contents
