Table of Contents
Advertisement
Installation
3.6 Installation
3.6.1 General information
Parts which must be assembled are prepacked inside each machine section to-
gether with the necessary bolts, nuts, etc.
Remove all lower cover plates (6).
The final position of the machine is either free-standing in the room or placed with
the back against a wall. If the machine is to be placed against a wall, the assembly
should be carried out with sufficient space behind the machine for access during
the fitting of components on the back of the machine. The fully assembled ma-
chine is then pushed into position.
The picture below shows a machine with the feed direction from right to left. The
picture shows parts which must be assembled during the installation and the ad-
justing device for tensioning the conveyor belt.
4
5
6
1.
Adjusting screws for the conveyor belt
2.
Tension wheel
3.
Coverplate
4.
Upper track
5.
Chain
6.
Coverplate
7.
Overflow pipe
8.
Drainage plate
9.
Lower track
10.
Belt tensioner
WD-59CT & WD-66CT
7
8
10
Rev. 2.0 (20110124)
3
2
9
10
66CT_04
1
Advertisement
Table of Contents
