Table of Contents
Advertisement
Installation
3.6.4 Assembling the track and conveyor belt
Screw the upper and lower tracks (4.9) of the conveyor belt together at the join
between the sections using the support plates and nuts supplied.
66CT_09
Locking the upper and lower tracks.
A=Upper track
B=Joint
C=Flange nuts
D=Support plate
E=Lower track
•
Fitting the drainage plate (8).
•
Joint the belt if it is in position in the machine.
•
If the belt is not in position, the installation is carried out as follows:
•
Feed in the belt on the upper track through the outfeed opening. Pull the
belt through the machine through to the infeed opening and around the ten-
sion wheel (2).
•
Use a piece of rope and pull the belt back on the lower track to the outfeed
opening. Join the ends of the belt.
•
Tension the belt. Undo the screws for the belt sections (10). The screws
are accessible from the inside of the infeed section. Tension the belt using
the adjusting screws (1). When the belt is tensioned correctly, it should be
possible to lift it by about 2-3 cm at the centre of the infeed. Tighten the
screws for the belt tensioners (10).
WD-59CT & WD-66CT
A
B
C
D
E
C
D
14
Rev. 2.0 (20110124)
Advertisement
Table of Contents
