Table of Contents
Advertisement
Instructions for use
Troubleshooting
Problem
No indication on the control panel dis-
play when the power is switched on
by pressing button (10).
The machine does not fill with water.
The machine does not stop filling.
Noise from the wash pump.
The machine is not cleaning properly.
The dishware tips over.
The washed items do not dry.
Troubleshooting
In addition to the faults shown on the control panel, other faults can occur. The
table below shows some faults which can be rectified by the operator. If the prob-
lem persists, contact authorised service personnel.
Cause
The main switch (18) is off.
The stopcock on the in-
coming water supply is
closed.
The outlet seals are not in
place.
The rubber sleeve on one
of the outlet seals is not
sealing against the bottom
plate.
Low water level in the tank.
Foam in the tank.
The rinsing and washing
nozzles are clogged with
dirt.
There is too little deter-
gent.
Foam formation in the
washing tanks.
Dirt has dried on the items
to be washed.
The rinsing pressure is too
low.
The water in the tanks is
too dirty.
Rinsing pressure is too
high.
The rinsing nozzles are
blocked.
Too little drying agent.
When you contact service personnel, you will need to provide the following infor-
mation:
•
Machine model
•
Machine serial number and installation date
•
A brief description of the problem
•
What happened immediately before the fault occurred
WD-59CT & WD-66CT
Action
Turn on the mains switch.
Open the stopcock.
Fit the outlet seals.
Check that the outlet seals are closed.
Replace the rubber sleeves, if they are
damaged.
Check that the tank's outlet seal is closed.
Change the rubber sleeve if it is dam-
aged.
Change the water.
Check and clean the nozzles.
Check the amount of detergent.
Check that the washing temperature is
not too low and that the correct detergent
is being used. Change the water if foam
forms.
Soak the items before washing.
Check that lever (24) for setting normal or
heavily soiled loads is in the correct posi-
tion. (Extra equipment).
Change the water.
Check that lever (24) is set to the position
for normal loads. (Extra equipment).
Check and clean the nozzles.
Check the quantity of drying agent.
37
Rev. 2.0 (20110124)
Advertisement
Table of Contents
