Installation
3. Installation
3.1 General information
3.2 Requirements for the installation site
3.2.1 Lighting
3.2.2 Ventilation
3.2.3 Drain
The machine must be installed by authorised personnel only.
Read these instructions carefully, as they contain important information regarding
the correct installation method.
The instructions should be used together with the machine drawing, wiring dia-
gram and flow diagram.
The machine is CE marked. The CE mark is only valid for machines that have not
been modified. If the machine is damaged as a result of the instructions not being
followed, this invalidates the supplier's guarantee and the product liability.
In order to ensure the best possible working conditions during installation, opera-
tion, servicing and maintenance, make sure that the machine is installed in a well-
lit room.
The machine produces heat and steam when in operation. In order to ensure the
best possible working conditions, a certain air change rate is required in the dish-
washing room. The ventilation requirements for the room are calculated as per
applicable standards.
There must be floor drains for the machine's waste water and for water used for
cleaning. For the size, capacity and location of floor drains, see the chapter enti-
tled "Connections".
WD-59CT & WD-66CT
6
Rev. 2.0 (20110124)