Timing / Power On - Safran LRF 7047 Manual

LRF 7047- Integrator Manual

6.4 Timing / Power on

 The inter character delay shall be lower than 5 ms (independent from the baud rate).
Once a valid command is fully received by the module, an acknowledge (AC) or not acknowledge (NA)

response is sent back within 10 ms.
Not valid commands are ignored by the module.

The module responds to non-distance related commands within a maximum of 210 ms (first byte).

 The module responds to distance related commands within a maximum of 300 ms** (first byte).
Wake-up delay:

"Stand-by Mode" to "Normal operating Mode" delay is lower than 75 ms.
o
"OFF Mode" to "Normal operating Mode" delay is lower than 75 ms.
o
Start-up delay:

from "Disconnected" to "Normal operating Mode", and
o
from "Disconnected" to "OFF Mode" and then to "Normal operating ode" delay is lower
o
than 75 ms.
The maximal duration of a IBIT test is lower than 150 ms

The maximal duration of a PBIT test is lower than 150 ms

**This timing is accurate for isolated single range request commands. For closely stacked single range
requests commands this timing may be increased to up to 1 second, in order to comply with eye safety
limitations. This timing is dependent on range conditions.
Range commands for continuous and block request already watch out the eye safety buffer.
914929_TML_LRF7047_en_Version B
Confidential & Proprietary  Safran Vectronix AG – All rights reserved
Public: 04.2019
Page: 41/72