Mounting The Lrf Module With Detached Laserbox - Safran LRF 7047 Manual

LRF 7047- Integrator Manual
4.4.1

Mounting the LRF module with detached Laserbox

In order to mount and operate the LRF 7047 with a detached Laserbox follow the steps below:
1. The LRF module must be unplugged
2. Loosen both screws (A) with a T5 screwdriver and remove the flexcable protective cover
3. Loosen both screws (B) with a T6 screwdriver and remove the Fiber protective cover
4. Carefully remove the fiber from the holder and unroll
Warning
The bending radius of the fiber should not be less than 5mm

 Do not kink the fiber
Do not pull the fiber connectors

5. After the fiber has been unrolled, reattach the Fiber protective cover and tighten the screws to
30 Ncm
6. Unscrew the four Laserbox mounting screws (C) using a T10 screwdriver and remove the screws
7. Carefully lift the Laserbox
8. Remove the washers from the 4 rubber spacers
9. Unscrew and remove the 4 rubber spacers
10. Screw the 4 rubber spacers into M4 screw holes at the desired location and tighten them. A
clearance of 5 mm on each side of the Laserbox has to be available to allow movement of the
Laserbox due to shock and vibration
11. Replace the 4 washers onto the rubber spacers
914929_TML_LRF7047_en_Version B
Confidential & Proprietary  Safran Vectronix AG – All rights reserved
Figure 13: LRF 7047 with detached Laserbox
Public: 04.2019
Page: 23/72