Table of Contents
Advertisement
30
5.5. Mounting the Product
5.5.1. Mounting the Product
Dimensions of wall bracket (mm)
The steps to mount the product are listed below:
a. Remove the wall bracket from the product, place it on the wall where the product
will be mounted, and use a marker to locate the drill positions.
b. Drill 6 holes on the wall with Φ10mm drill and insert the screw anchors into the
drill holes.
c. Attach the wall bracket to the wall and tighten the screws with the tool of SW10
hexagon sleeve.
d. Hold the inverter by using the handles at two sides, and install the product on the
wall bracket. This step should take two people to complete.
e. Tighten the wall bracket and the product with screw M6*16 (X6) (tool: T20
screwdriver, torque: 3.0 Nm).
f. Loosen a few turns of the two screws, hang on the cable cover of the battery
breaker, and then tighten the two screws.
1
1
T20
SW10
2
Ø10mm
≥70mm
*
≥1000mm
*Depending on quantity of the expansion batteries
Mounting
(X6)
3
Advertisement
Table of Contents
Troubleshooting
