Fujitsu AIRSTAGE J-II Design & Technical Manual page 631

Hide thumbs Also See for AIRSTAGE J-II:

Table of Contents

COMPLETION OF FUNCTION SETTING MODE

8) To clear the function setting mode and return to the regular display, hold down the three

buttons of SET TEMP. V, SET TEMP. Λ and FAN at the same time.

If no key entry is made for 60 seconds, even though none of the above buttons is

pressed, the function setting mode will automatically be cleared.

(If the function setting mode is automatically cleared while setting addresses,

activate the mode again according to the procedure in step 3) above.)

SETTING UP EACH INDOOR UNIT

Wired remote

Repeat the procedures in steps 1) through 8), and set up the indoor units

requiring function setting.

RESET THE POWER AFTER SETTING UP FUNCTION OF ALL

INDOOR UNITS

If the reset is not performed, function can not be read in normally.

After all the functions have been set, the circuit breaker needs to be switched off

for at least 2 minutes.

After the 2 minutes has passed, power can be restored.

The set function is stored in the PCB and will remain in memory even when the

power is turned off.

However setting function is effective after power reset.

Record the function set in the indoor unit on a label, etc., and affix the label to the

unit so it can be used for after-sales service operations.

- (07-105) -

Normal mode display

Wired remote

Chapters

Table of Contents