Fujitsu AIRSTAGE J-II Design & Technical Manual page 545

SWITCHING SELECTION OF ADDRESS SETTING MODE
„ „
(3) Press and hold the "MANUAL/AUTO"
button for 3 seconds.
MANUAL AUTO
IR RECEIVER UNIT
● The position of the "MANUAL/AUTO" button varies depending on the model.
Refer to the operation manual for the position that is included with the unit.
● The error will be displayed by continuously pressing the "MANUAL/AUTO" for 10 sec or more. In this case
release the button or turn off the power.
● An explanation of the displayed information as shown below.
SELECTION AND CONFIRMATION OF CUSTOM CODE
„ „
(5) Press the " SET TEMP.
TEMP. " buttons to select the custom
q
code that matches the setting with the
indoor unit.By selecting the appropriate
custom code, the communication between
the indoor unit and the wireless RC
become possible.
CUSTOM CODE
( - - - )
The initial setting is " "
(4) Press and hold the "FAN" and the " SET
Pi Pi Pi
MANUAL
AUTO
" or " SET (6) Press the "TIMER MODE" button to send
p
- (07-19) -
TEMP. " buttons. Whilst holding these
p
2 buttons, press the "RESET" button.
FAN
SET TEMP. ( )
RESET
the code to the indoor unit.
Correct code:
Wrong code:
No Response
Function setting
mode display
Pi Pi