Fujitsu AIRSTAGE J-II Design & Technical Manual page 530

KINDS OF ADDRESS AND SETTING RANGE
„ „
UNIT SETTING
Refrigerant
O
circuit address
RB unit
P RB unit address
Touch panel
G Controller /
controller
Convertor
address
Network
H
convertor Refrigerant
circuit address
Group remote
Group remote
I controller
controller
address
Wired, simple
Dual remote
remote
J
control
controller (3-
wire type)
Signal Signal amplifier
K
amplifier address
Network
convertor for M
Controller /
L W
ORKS ®
ON
Convertor
Central
address
remote N
controller
Remote
F controller
Wired remote
address
controller (2-
wire type)
Dual remote
control
*Set up after confirming the details of each unit.
*1: The sum total of the Touch panel controller, Central remote controller, Network convertor for Group remote controller
and Network convertor for L
Note: Address of the Touch panel controller, Central remote controller, Network convertor for Group remote
controller and Network convertor for L
*2: The address can be set from 1 to 32. However, do not set the same number as that for the remote-controller
address of an indoor unit connected using the same remote-control cable.
Please set "Remote controller address" of Wired remote controller (2-wire type) in Manual address setting only. It is
not necessary to set in Automatic address setting.
SETTING
RANGE
n Manual address setting
Setting
00 ~ 99
example
01
n Automatic address setting
Set this switch to 00 at factory setting.
n Manual address setting
Setting
00 ~ 63
example
12
n Automatic address setting
Set this switch to 00 at factory setting.
00 ~ 15
*1
Setting
example
00 ~ 99 01
00 ~ 03
ON/OFF SW 2 of DIP Switch 1
n Manual address setting
1 ~ 8
n Automatic address setting
Set to 1 at factory setting.
00 ~ 15
*1
1 ~ 32
n Manual address setting
*2
0 ~ 15 n Automatic address setting
ON/OFF
®
W is a maximum of 16.
ON ORKS
W ® must not be same.
ON ORKS
- (07-04) -
TYPE OF SWITCH
REF AD REF AD
x10 x1
RB AD RB AD
x10 x1
SW 110 SW 111
(10 digit) (1 digit)
REMARKS
Arbitrary numbers can be
set in range of 00-99
See the setting method 1-5-3.
Arbitrary numbers can be
set in range of 00-63
See the setting method 1-5-3.
See the setting method 2-11
See the setting method 2-14
See the setting method 2-10
See the setting method 2-9
See the setting method 2-15
See the setting method 1-5-1
See the setting method 2-14
See the setting method 2-12
See the setting method 2-13-1
See the setting method 2-13-2