Fujitsu AIRSTAGE J-II Design & Technical Manual page 562

Hide thumbs Also See for AIRSTAGE J-II:

Table of Contents

3) Turn on the power to the indoor unit.

By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and

vacuuming have been conducted before turning on the power.

Also check again to make sure no wiring mistakes were made before turning on the power.

SWITCHING SELECTION OF ADDRESS SETTING MODE

4) When the [Function Setting] on the "Maintenance" screen is touched, the "Installer

Password Verification" screen is displayed.

Enter the Installer Password, and touch the [OK]. "Function Setting" screen is displayed.

I.U. Address

Function Setting

R.C. Address

Function Setting

Function No.

Address setting mode initial display

Chapters

Table of Contents