Model Selection Procedure - Fujitsu AIRSTAGE J-II Design & Technical Manual

1.

MODEL SELECTION PROCEDURE

Selection of indoor units
Selection of required optional parts
● Cassette grille for all Cassette type
● EV kit for AS  E04-14
Selection of outdoor unit
Selection of controller units
● System Controller
● System Controller Lite
● Touch Panel Controller
● Central Remote Controller
● Group Remote Controller
● Wired Remote Controller
● Simple Remote Controller (with operation mode)
● Simple Remote Controller (without operation mode)
● Wireless Remote Controller
Selection of adaptor / convertor
● Network Convertor
● Network Convertor for L
ON
® Gateway
● BACnet
● Signal Amplifier
● External Switch Controller
Selection of branch kit
● Separation Tube
● Header
Selection of other optional parts
● Flange (square)
● Flange (round)
● Long-Life Filter
● IR Receiver Unit
● Remote Sensor Unit
● Drain Pump Unit
● Air Outlet Shutter Plate
● Panel Spacer
● Wide Panel
● Insulation Kit for High humidity
● Fresh air intake kit
● Auto louver grille kit
END
®
W
ORKS
- (02 - 01) -
See 2-2.MODEL LINE UP (INDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-1.MODEL LINE UP (OUTDOOR UNIT) and
3-1. SELECTION PROCEDURE OF INDOOR UNIT AND
OUTDOOR UNIT
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)
See 2-3.MODEL LINE UP (OPTIONAL PARTS)