Indoor Unit (Setting By Wireless Remote Controller) - Fujitsu AIRSTAGE J-II Design & Technical Manual

2-3.

INDOOR UNIT (setting by wireless remote controller)

This procedure changes to the function settings used to control the indoor unit according to
●
„
the installation conditions. Incorrect settings can cause the indoor unit malfunction.
After the power is turned on, perform the "FUNCTION SETTING" according to the
●
„
installation conditions using the remote controller.
The settings may be selected between the following two: Function Number or Setting
●
„
Number.
Settings will not be changed if invalid numbers or setting numbers are selected.
●
„
PREPARATION
„ „
(1) Turn on the power to the indoor unit.
By turning on the power indoor units initializes EEV, so make sure the piping air-tight test and vacuuming
¾
have been conducted before turning on the power.
Also check again to make sure no wiring mistakes were made before turning on the power.
¾
Breaker ON
Indoor
units
- (07-95) -
Indoor
Indoor
units
unit