Get Started - Saadat DENA 1210 User Manual

Chapter 1: Introduction

Get started

1- Open the package and take out the DENA 1210 and accessories carefully. Keep the package
for possible future transportation or storage. If trolley is available, assemble it according to its
instruction and place the electrocardiograph on it properly.
• Check the device for any mechanical damage.
• If there is any problem, contact the distributor immediately.
2- Connect the power cable to the device.
• Make sure the AC power supply complies with 100-240 VAC, 50 /60Hz.
• Plug the power cable to the power supply socket of the device. Connect the other end
of the power cable to a grounded power receptacle.
3- Power on the DENA 1210.
• Press the Power key to turn on the electrocardiograph.
4- Connect the patient cable. Connect all necessary accessories to patient and the DENA 1210.
Warning
• If any sign or error message is observed in DENA 1210 that may be due to its failure,
please do not use the device on the patient until the sign or error is eliminated.
In the following, the different parts of this device will be explained.
3