Chapter 1: Introduction
Intended Use
Dena is an advanced electrocardiograph which is designed to record electrical signals of the heart
in up to six channels (10-wire) using a thermal printer with adjustable filter, gain, speed, and mode.
This device is applicable to adults and neonates in all parts of the medical center and used by
healthcare professionals for diagnostic purposes.
Getting started
1- Open the package.
Open the package and take out the electrocardiograph and accessories carefully. Keep the
package for possible future transportation or storage.
■ Check the device for any mechanical damage.
■ Check existence of accessories and contents according the following checklist:
Electrocardiograph device
Patient cable
Recorder thermosensitive paper
Limb electrode (wrist electrode
clamping)
Chest electrode (suction bulb)
Gel
Power cable
User manual
Guarantee card
Calibration certificate
If there is any problem, contact the distributor immediately.
2- Connect the power cable to the device.
■ Make sure the AC power supply complies with the following specification:
100-240 VAC, 50 /60Hz.
■ Plug the power cable to the power supply socket of the device. Connect the other end of the
power cable to a grounded power receptacle.
1 unit
1 piece
1 roll
Set of 4
Set of 6
1 packet
1 piece
1 copy
1 copy
1 copy
3