Bottom Panel - Saadat DENA 1210 User Manual

Electrocardiograph
Hide thumbs Also See for DENA 1210:
Table of Contents

Advertisement

Chapter 1: Introduction

Bottom panel

The following parts are located in the bottom panel of the device (Figure 1-5):
Handle: Used to move and carry the device.
Battery compartment: The device battery is placed in this box.
Fast 3A fuse
Bottom label
Built-in battery
The Dena 1210 electrocardiograph has a rechargeable battery. The battery starts charging
automatically when the device is connected to AC outlet. Turning the device on and off has no
effect on charging the battery.
The charging and discharging time of the device can vary according to the type of battery used
(its types are described in the Technical Specifications chapter) and also the duration of use.
When the device is plugged in and charging, the battery indicator shows a gradual charge in
green. When the device is not connected to the power supply, the battery indicator shows the
remaining charge in green. When the battery is running low, the charge level is shown in red.
Warning
• If the device is not to be used for a long time (more than 10 days), remove the fuse
from the device to prevent full discharge of the battery.
• If the battery discharge time is less than 1 hour, the battery is defective and contact
after-sales service to replace it.
• DENA 1210 will turn off automatically if the battery power is too low. When the
electric power is going out, the message "BATTERY LOW" will be displayed.
Use only the manufacturer recommended batteries. Other batteries may cause a fire.
1
2
3
Figure 1-5 Bottom panel
11
4

Advertisement

Table of Contents
loading

Table of Contents