Saadat DENA 1210 User Manual page 8

Patient's safety
• Before using the Dena 1210 electrocardiograph, the operator must ensure the safety
and correct operation of the device and its accessories. (Device calibration date must
be valid).
• Do not touch the patient, bed or devices nearby during defibrillation.
• Disposable electrodes are recommended when using electroshock and electrosurgery
with an electrocardiograph.
• When defibrillator is used, the signals may be disturbed for a few seconds, after
which the device will continue to operate normally.
• For people who have a pacemaker, be sure to enable the pacemaker detection feature
on the device.
• The physician shall consider all known side effects when using the Dena 1210
electrocardiograph.
• To prevent the environment pollution, the device and accessories (e.g. battery) shall
be disposed in accordance with national laws after their useful lives. Contact your
municipality to check where you can safely dispose of old batteries.
• Do not connect devices that are not part of the Dena 1210 electrocardiograph.
• Do not expose DENA 1210 near any local heating item such as the direct radiation.
• It is possible to increase leakage current when touching the patient and connected
devices, or when several systems as well as DENA 1210 are connected to the patient
simultaneously.
• Due to the possibility of explosion, the equipment is not suitable for use in the
presence of a flammable anaesthetic mixture or in oxygen-rich places.
• To protect patient against the electrical shock hazards, DENA 1210 needs to be
connected to grounded power receptacle.
• The location of the device shall be such that when necessary, the plug of the device
can be easily disconnected from the electrical outlet.
• If any liquid is spilled on the system or accessories, immediately turn off the system
and wipe up it by a soft cloth. If water seeps into the device, it should be inspected
by trained personnel before reuse.
• Electric and magnetic fields cause the device to malfunction. The Dena 1210
electrocardiograph must be installed and serviced in accordance with the information
in Appendix 3 Electromagnetic Compatibility (EMC).
• To prevent EMC effect on DENA 1210, it should not be used adjacent to or stacked
with other equipment and that if adjacent or stacked use is necessary, the system
should be checked for normal operation in the configuration in which it will be used.
• Do not use DENA 1210 during X-ray and Magnetic Resonance imaging. Induced
current could potentially cause burns and may affect the accuracy of DENA 1210
measurements. DENA 1210 may also adversely affect MRI and X-ray images.
IV