Rhythm Recording - Saadat DENA 1210 User Manual

Chapter 4: Recording Operation

Rhythm Recording

By selecting Rhythm from the Rec Mode menu using the keyboard or by touching the screen,
the waveform corresponding to the selected rhythm lead(s) (one to three leads) is drawn on the
screen. In this mode, according to the number of selected leads, the screen is divided into one
to three parts and displays one of the leads in each part. Pressing the "Start / Stop" key on the
front panel of the device or display starts the signal storage phase according to the time
specified in the Length of Rhythm (the data acquisition message is displayed. The record key
on the display turns blue and a counter on it counts down to zero from the set time), and then,
a record is taken of the stored signal.
Note
• During Manual recording in +3, 6 or +6 modes, you can record from the previous or
next set of leads by pressing the Lead▼ and ▲Lead keys.
• In manual mode, after the recording starts, the recording stops just by pressing the
"Start / Stop" key again.
• When recording in all modes, you can stop recording by pressing the "Start / Stop"
key in front panel or touching the "Stop" key in the screen.
• Copy key is used to retrieve the last record (except manual modes). By turning the
device on and off due to the lack of a previous record, the information cannot be
copied.
37