Table of Contents
Advertisement
Chapter 1: Introduction
DENA 1210 has a TFT color screen. The 12-wave ECG waveform, HR numerical value,
patient name and ID, date and time, device status and system messages are displayed on this
screen. The screen can be divided into three parts:
- Header area (figure 1-3-
),
- Menus and touch keys (figure 1-3-
), and
- Waveform and message area (figure 1-3-
).
Figure 1-3 DENA 1210 display screen (with messages)
Header Area
The upper section of the screen is called Header Area. The parameters displayed in this area
include the numerical value of the HR, time, date and operating conditions of the device. This
information is always displayed on the screen when the device is on. Touch keys to change the
display mode, access the settings and archive menus are also in this area. According to the
battery conditions during operation of the device, the corresponding symbol is displayed in the
Header Area.
It should be noted that the numerical value of HR is measured and updated in real-time.
Menus and touch keys
Using this section, you can easily change the recording settings. The function of each of the
keys in this section is similar to the equivalent key function on the device keyboard (control
panel). More details can be found in the System Settings chapter.
Waveform and message area
12-lead ECG waveforms or Rhythm lead waveforms are displayed on the screen. The name of
the lead is displayed on the area corresponding to the ECG waveform. In the lower right corner
of this section is the touch record key, which functions exactly like the Start / Stop key on the
keyboard. The green color of this key means that touching it starts recording. When recording,
5
Advertisement
Table of Contents
Troubleshooting
