Table of Contents
Advertisement
Chapter 8. Getting Started
Chapter 8. Getting Started
8-1 Open the package.
Open the package and take out the electrocardiograph and accessories carefully. Keep the
package for possible future transportation or storage.
■ Check the device for any mechanical damage.
■ Check existence of accessories and power cable.
If there is any problem, contact the distributor immediately.
8-2 Connect the power cable to the device.
■ Make sure the AC power supply complies with the following specification:
100-240 VAC, 2- 0.8 A 50/60 Hz.
■ Plug the power cable to the power supply socket of the device. Connect the other end of the
power cable to a grounded power receptacle.
Make sure that the battery indicator lights. If it does not light,
check your local power supply and power cable connection. If the
problem still exists, contact the After -Sales Services department.
The battery needs to be charged after transportation or storage.
If the power cable is not plugged in before turning on the device, the
device may not work properly because of insufficient power.
Connect the device to AC INPUT for about some hours while it is
off.
8-3 Power on the electrocardiograph system.
Press Power key to turn on the electrocardiograph.
The battery must be recharged after a while to ensure adequate
electricity reserve. To do so, you only connect the system to AC
INPUT.
If any sign or error message is observed in the device that may
be due to its failure, please do not use it on the patient.
43
.
.
Advertisement
Table of Contents
