Table of Contents
Advertisement
Appendix 3: Electro-magnetic compliance
Warning
• Use only the recommended manufacturer accessory. Using the accessory other than
in relevant chapter may cause to increase the EMISSION or decrease the
IMMUNITY of system.
• Measurements can be affected by mobile and RF communications equipment. It
should be assured that DENA 1210 is used in the electromagnetic environment
specified.
• To prevent EMC effect on DENA 1210, the system should not be used adjacent to or
stacked with other equipment and that if adjacent or stacked use is necessary, the
equipment should be observed to verify normal operation in the configuration in
which it will be used.
• Do not use cellular phone in the vicinity of this equipment. Strong level of
electromagnetic radiation emitted from such devices may interfere with DENA 1210
performance.
Guidance and manufacturer's declaration – electromagnetic emissions
The DENA 1210 Electrocardiograph is intended for use in the electromagnetic environment
specified below. The customer or the user of the DENA 1210 Electrocardiograph should
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Harmonic emissions
IEC 61000-3-2
Voltage
fluctuations/ flicker
emissions
IEC 61000-3-3
Compliance
Electromagnetic environment - guidance
The DENA 1210 electrocardiograph uses RF
energy only for its internal function. Therefore, its
Group 1
RF emissions are very low and are not likely to
cause any interference in nearby electronic
equipment.
Class B
The DENA 1210 electrocardiograph is suitable
Complies
for use in all establishments, including domestic
establishments and those directly connected to the
public low- voltage power supply network that
supplies buildings used for domestic purposes.
Complies
76
assure that it is used in such an environment.
Advertisement
Table of Contents
Troubleshooting
