Table of Contents
Advertisement
4.1.
Saw band dismantling
During the dismantling, take care that you do not damage the limit switch if the saw
band stretching.
1.
Lift the saw frame to the top position. Stop the saw frame in top position by
control valve.
2.
Dismantle yellow protective cover of the saw band. The cover is clamped with two
screws.
3.
Open the cover of the arm.
4.
Turn by stretching star to the left side, release saw band stretching and pull saw
band from blade wheels.
5.
Pull up the saw band from the guiding cubes
4.2.
Saw band mantling
During the installation, take care that you do not damage the limit switch if the saw
band stretching!
1.
Prior to installation, clean all track wheels, guide cubes and inner side of the arm
thoroughly of all traces of chips and dirt. Keep in mind the teeth direction when
installing the saw band.
41
Advertisement
Table of Contents
