Driving Wheel Replacement - Bomar Workline 410.280 DG Operating Instructions Manual

4.10.5.
54
8. Insert the bearing to the hole in the wheel and press it to the retaining ring.
9. Put the wheel on the shaft and screw on the preparation to the wheel stretching
to the hole in the shaft.
10. Pull on the wheel on the shaft.
11. Screw on washer and screw back..
12. Install the saw band. Wheel replacement is ready.

Driving wheel replacement

1. Dismantle the saw band
2. Screw off the screw and remove the washer.
Manual version: 1.02 / Nov. 2011
Manual rev.: 1