Table of Contents
Advertisement
TOTAL – STOP button
1
In emergency causes the machine must be immediately switched off.
Machine Turn ON/OFF
2
Switch into position 1 to turn ON the machine or into position 0 to OFF.
Cooling system selection
You can select from three possibilities:
Cooling with Microniser (optional accessories)
3
0
Cooling is switched on when the drive is running.
Rinsing Machine, cooling pump works even when saw band drive not run.
START - Switch on the semi-automatic cycle
4
Push of a button starts the cutting cycle Button STOP stops cutting cycle.
STOP - Switch off the engine of the band saw
5
Stop cutting cycle.
Frequency convertor
6
Turn to change the speed of the saw band.
Saw arm rapid move into cut
Pressing the button starts a saw arm rapid falling into cut, without the operator had to change the
speed of falling through the governing valve.
7
ATTENTION!
Do not use rapid move when saw blade is in cut! This button can be used only for the rapid
movement ABOVE material!
Governing valve
Adjust the speed of the arm sinking to the cut by governing valve.
8
ATTENTION!
If you keep closing the throttle valve too tightly, the valve seat may wear off which causes its
leakage. Therefore, close the valve always gently.
3.3.
Machine control
1.
Set the cutting angle.
2.
Lift the saw arm to the top position.
3.
Open the vice by pressing button and insert material.
4.
Clamp material to the vice.
5.
Press button START. The arm begins fall into the cut and the drive for sawbelt is
started. For speed up saw arm falling into the cut is possible push the button on
pos. 7 – saw arm rapid move into cut. Stop the rapid move at least 10 mm above
material. Do not use the rapid move, if the blade is in the cut.
Attention!
Do not move the saw frame to the material, when the saw band
driving is not running! Do not move the saw frame to the
material with accelerated motion! The saw band can be
damaged!
6.
Remove cutted material from vice.
7.
You can repeat whole process.
33
Advertisement
Table of Contents
