Table of Contents
Advertisement
4.10.
4.10.1.
4.10.2.
50
Worn pieces replacement
Hard metal guides replacement
If the hard metal guides cannot be adjusted, they have to be replaced.
1.
Dismantle the saw band. Remove the hosepipe leading the cooling agent.
Dismantle guide cube of the saw band.
2.
Loosen the adjusting screws of the metal guide.
3.
Loosen the binding screw of first metal guide. Remove adjustable hard metal
guide.
4.
Loosen the binding screw of second metal guide. Remove the hard metal guide
5.
Insert new hard metal guides and fasten them tightly.
6.
Mount the saw band. Adjust the hard metal guides.
Round brush replacement
If the chip removing brush is so worn, that it does not fulfil its function, the brush must
be replaced.
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
