Table of Contents
Advertisement
1.
Release the nut of the brush, exchange old brush to new brush and screw on the
nut of the brush.
2.
Set the brush to the saw band.
4.10.3.
Saw band guiding rollers replacement
If the saw band is not sufficiently guided by guiding pulleys or if the pulleys are
obviously worn, the pulleys should be replaced.
ATTENTION!
Guiding pulleys must be replaced together on both guiding
cubes!!
1.
Dismantle the saw band.
2.
Disconnect the hose from the cooling agent, screw off the pressure regulation. Let
the pressure regulation connected to the hydraulic system. Dismantle the guiding
cube of the saw band..
3.
Tighten the guiding cube to the vice and dismantle both eccentrics with bearings
following way.
ATTENTION!
Mark both eccentrics placing and components on the eccentric!
Eccentrics must not be replaced with each other!!
4.
Screw off nuts from eccentrics..
5.
Remove eccentrics from bearings by means of the swager
51
Advertisement
Table of Contents
