Table of Contents
Advertisement
56
3.
Remove the cover of the pump terminal switchboard. Disconnect 4 terminal
connectors of the input cables. Cables are identified according to the red clamps..
4.
Loosen the bushing and pull the cable out from the pump.
5.
Dismantle new pump switchboard cover. Push the cable through the bushing and
fasten it.
6.
Screw on the cable bushing and cover of the terminal block. Do not forget the
rubber gasket! Tighten the cooling liquid hose with non-stick tape and screw it
again. Install cooling liquid hose, place the pump on the sheet metal holder and
screw it
.
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
