Table of Contents
Advertisement
2.8.
2.9.
2.10.
2.10.1.
2.10.2.
26
Filling of the cooling system
Prepare the mixture of the water and the cooling liquid. Keep the concentration
specified by manufacturer. Shift away the cover from the drainage hole. Fill the mixture
of the water and the cooling liquid to the tank of the cooling system. Area of the tank
for the cooling liquid is discovered from the chapter Technical data.
Let the drainage hole opened and with the sieve during operation, because it secures
the right work of the cooling system. Filling the tank with the cooling liquid, take care
that the liquid does not drip out of the tank and the tank does not overflowed.
Note:
If machine is equiped with microniser, fill microniser with
prescribed cooling liquid. This made the Microniser ready for
use.
Check machine function
Check, if the machine or some parts of the machine were not damaged during
transport.
Check, if covers are installed and functional. Check by means of the Tenzomat if the saw
band is correctly stretched. If it is necessary, you can stretch the saw band according to
chapter Selection and replacement of the saw band. Values of the saw band stretching are
on the Tenzomat. Switch on the main switch and check the motors and systems (saw
band drive, hydraulic pump, cooling pump, chips conveyor).
Open and close the main vice. Turn the saw frame of the band saw from one outer
position to other outer position. Raise the saw frame to the top position and drop the
saw frame to the lowest position.
Start the machine with the cooling pump and let it run without load until the cooling
system will be filled with cooling liquid. As soon as the cooling liquid starts to escape
from the nozzles of the cooling system, the cooling system is ready for the operation.
Carry one cycle of cutting without material. Check, if the machine runs with no
irregularities. If all machine functions are right, the machine is ready for operation..
Saw band
Refit the saw band cover only after you have installed and tightened the saw band.
Saw band size
3800×27 (25)×0,9 mm
Selection of the saw band tooth system
The manufacturers provide the saw bands with constant and variable tooth system. The
important factor for selection of the tooth system is length of the cutting canal with
respect to the size of the product
1.
Constant tooth system – the saw band has parallel tooth pitch all over length. This
way is suitable for cutting of solid material.
BOMAR recommended Variable tooth system for band saw.
2.
Variable tooth system – tooth pitch is variable. Variable tooth system is used for
profiled materials and bundle cutting. Variable tooth pitch lowers vibration of the
saw band, increases service life of the saw band and quality of the cutting area.
In tables, there are advised type of the tooth system depending on sizes and form of
the cutting material.
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
