Table of Contents
Advertisement
3.4.5.
3.4.6.
3.4.7.
3.4.8.
36
Adjustment of pressure to the cut
For cutting extremely hard materials operator can add strength to the cut by the M16
nut on spring holder.
Speed adjustment of the arm lowering
Speed of the arm lowering is adjusted by regulation valve on control panel – pos. 8.
•
Set the lower speed of the arm lowering to the cut by turning the switch
clockwise.
•
Set the higher speed of the arm lowering to the cut by turning the switch anti-
clockwise.
Notice:
If you keep closing the throttle valve too tightly, the valve seat
may wear off which causes its leakage. Therefore, close the
valve always gently.
Saw frame lower stop position
The lower stop limits the lowest position of the saw frame. This stop point has to be
checked at least once a month. If the lower stop point is incorrectly adjusted, the
cutting table can be damaged or the material will not be cut completely.
Setting the lower stop position is set using the screw in Console.
Brush adjustment
The brush for chip removal from the saw band influences cutting durability saw band
lifetime and wheels lifetime, hard metal guides and finally the cut accuracy. Brush
adjustment must be checked every shift.
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
