Table of Contents
Advertisement
3.3.1.
3.4.
3.4.1.
34
Cycle breaking
•
»
STOP button
Semi-automatic cycle is interrupted by pressing button 5 – STOP of the cycle
The arm stops fall into cut and saw blade is stoped.
By pressing button 4 – START of the working cycle, you can start the cycle.
•
TOTAL STOP button
In case of the risk, press button TOTAL STOP.
After pressing TOTAL STOP button, saw band drive is immediately broken
and the arm sinking is stopped.
•
Reactivation
1.
Turn button TOTAL STOP according to the arrows (on the button).
2.
Lift saw arm above cutted material and push START button.
Band saw adjusting
Angular cut setting
1.
Release securing lever of the console, Swivel the frame to the desired angle by
pulling the saw arm. Angle is shown on scale. a páku znovu utáhněte. Then re-
tighten the lever.
2.
According to the cutting angle is needed to move the vice. For cutting angle less
than 0 ° move vice to the right, for cutting angle more than 0 ° move vice to the
left.
angle < 0°
angle ≥ 0°
Manual version:
1.02 / Nov. 2011
Manual rev.:
1
Advertisement
Table of Contents
