3.5.
3.5.1.
38
Machine control – automatic cycle
Cutting programs
The cutting programs are important part of the automatic cycle. It is possible to define
up to 20 programs. It is always started from program no. 1. All sequence of the
programs is performed, until the first program without any parameters set (both values
are zero).
To enter the cutting parameters selection mode:
Turn the key switch into position 0 – machine adjustment.
1.
Select Cutting modes item on LCD
2.
List of 20 programs is displayed; see section below Setting of the cutting parameters.
The other way to display the Cutting parameters selection mode is to use Preset
item in automatic cycle selection.
3.
Entering of the cutting parameters:
Function keys for Cutting programs selection:
Button
To move left in the values of Cutting programs table.
To move right in the values of Cutting programs table.
To move up in the values of Cutting programs table.
To move down in the values of Cutting programs table.
Description
Manual version:
Manual rev.:
1.10 / Jan. 2011
1