Table of Contents
Advertisement
1.3.
1.4.
10
Safety notes for machine operator
Attention!
Machine can be operated by person older than 18 years!
Machine can be operated only person physically and mentally
fit for this activity.
Machine can be operated only by one person. Machine operator is responsible for
presence of other persons by the machine.
Keep instructions and orders about work safety!
Read the operating instructions, before you start to work on the
machine! Keep the operating instructions in good condition!
Close covers before the machine starting and check, if the covers are not damaged.
Damaged covers must be repaired or changed. Do not start the machine, if the cover is
removed! Check, if the electric cables are not damaged.
Do not connect the machine to electricity if the covers are
removed. Do not touch the electrical equipment.
•
Do not hold the material for clamping to the vice and for cutting!
•
Do not operate with the buttons and the switches on the control panel, if you
have gloves!
•
For machine starting take care, that there is nobody in the working area of the
machine (it means in the working area of the vice, the saw band, the saw arm etc.).
•
In no circumstances touch the rotating elements.
•
Work on the machine only when the machine is in good condition!
•
Check at least once in a shift, if the machine is not damaged. If the machine is
damaged, you must bring the machine in order and you must inform your
superior!
•
Keep your working area clean!
•
Ensure sufficient lighting in the working area.
•
Take off the spilt water or the oil from the floor and dry it!
•
Do not touch the cooling liquid with bare hands!
•
Do not set the nozzle of the cooling liquid, when the machine is started on!
•
Do not remove the chips from the working area of the machine, when the
machine is started on!
•
Do not use the compressed air for the machine cleaning or for the chips
removing!
•
Use the protective instruments for chips removal!
Safety notes for the servicing and repairs
Switch off the main switch and lock it, before you start service work! When repair
machine remove power cord from the outlet. Otherwise, there is possibility of
hazardous machine starting.
Only qualified person can do the servicing and repairs. For parts changing, use only
parts, which are identical with the originals. Otherwise, there is possibility of health
hazard.
Use only recommended type of the hydraulic oils and oils and lubricants.
Do not remove or do not lock the limit switches or safety equipments! Any use of the
saw, accessories or machine parts other than that intended by the BOMAR, spol. s r.o.
company is not permitted.
Manual version:
1.00/ May. 2010
Manual rev.:
1
Advertisement
Table of Contents
