Power And Nmea Input Connection - Raymarine hsb2 PLUS Owner's Handbook Manual

Chapter 2: Installation

Power and NMEA Input Connection

The DC power and NMEA input should be connected at the rear Power/
NMEA seven-pin connector. The connector (viewed from the outside) and pin
functions are shown in the following diagram and table. The NMEA Input is
detailed in Section 2.7.
f
2
1
4
3
Pin No.
1
2
3
4
5
6
7
Figure 2-10: Power and NMEA Connector
Power Connection
CAUTION:
If the power connections are accidentally reversed the system will not
work. Use a multimeter to ensure that the input power leads are
connected for correct polarity.
Switch off the display unit before you remove the power cord.
The RED wire must be connected to the feed from the positive (+) battery
terminal and the BLACK wire to the feed from the negative (–) battery
terminal. The shielded wire (screen) should be connected to the ship's RF
ground as previously described in Grounding the System on page 2-14.Any
unused wires should be insulated and taped back.
Function
Channel 1 NMEA data input (+ve)
Channel 1 NMEA return (-ve)
Battery negative
Shield (drain wire)
Battery positive (12/24/32 V systems)
Channel 2 NMEA data input (+ve)
Channel 2 NMEA return (-ve)
5
7
6
D3231-2
Color
Orange
Yellow
Black
No insulation
Red
Green
Blue
2-17