Connections Overview; Power Connection - Raymarine CP200 Installation Instructions Manual

4.2 Connections overview

Use the following information to help you identify the
connections on your product.
Connector
Connector panel label Connects to:
Network
Power
Transducer Compatible
Making connections
Follow the steps below to connect the cable(s) to
your product.
1. Ensure that the vessel's power supply is switched
off.
2. Ensure that the device being connected to the
unit has been installed in accordance with the
installation instructions supplied with that device.
3. Ensuring correct orientation, push the cable
connector fully onto the corresponding connector
on the unit.
4. Turn the locking collar clockwise to secure the
cable.
Cables and connections
Suitable
cables
RayNet
Refer to the
network or Chapter 10
device. Spares and
accessories
section.
12 V / 24 V Supplied with
power supply. your product.
Supplied
transducer. with the
transducer.

4.3 Power connection

Note: For clarity, only the power-related cables
are shown in the illustration above.
Item Description
1 Power cable.
2 Red cable (positive)
3 Connection to 12 V /
24 V power supply.
4 Shield (drain) wire
5 Black cable (negative)
Power cable extension
The product is supplied with a power cable, which
can be extended if required.
• The power cable for each unit in your system
should be run as a separate, single length of
2-wire cable from the unit to the vessel's battery or
distribution panel.
• Raymarine recommends a minimum wire gauge
of 18AWG (0.82 mm
extension.
• Regardless of the length of the cable extension,
any cable used should be capable of achieving a
minimum voltage at the unit of 10.8 V with a fully
flat battery at 11 V.
Power distribution
Raymarine recommends that all power connections
are made via a distribution panel.
• All equipment must be powered from a breaker or
switch, with appropriate circuit protection.
• Refer to the Breakers, fuses and circuit protection
section for specific fuse and thermal breaker
ratings for this product.
Breakers, fuses and circuit protection
The information below is provided as guidance
to help protect your product. The example
illustrations provided are for common vessel power
arrangements, if you are unsure how to provide the
correct level of protection then please consult a
Raymarine authorized dealer for support.
2
Connects to:
Product's power
connector.
Power supply's positive
terminal.
Power supply.
Must be connected to
RF ground point.
Power supply's negative
terminal.
2 ) for any length of cable
1
D12947-1