Raymarine hsb2 PLUS Owner's Handbook Manual page 148

5-38
➤ To send the waypoint list on NMEA:
1. Display the waypoint list as previously described, then press the WAY-
WAYPOINT
TRANSFER
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON NMEA.
The soft key changes to STOP SENDING WAYPOINTS.
The waypoint and route lists are transmitted from the chartplotter to other
instruments on NMEA.
➤ To receive the waypoint and route lists via
both display units - one unit will send waypoints, the other will receive them.
CAUTION:
Receiving waypoints from another
existing waypoint and route lists.
1. Display the waypoint list as previously described, then press the WAY-
WAYPOINT
TRANSFER
POINT TRANSFER soft key.
2. Press the soft key SEND WPT LIST ON HSB or RECIEIVE WPTS FROM HSB; you
are prompted to confirm.
Press NO to cancel the operation, then ENTER if you wish to remove the
route list.
Press YES to continue. The waypoint list is transmitted to/from the chart-
plotter from/to another instrument on
ferred the soft key changes to STOP SENDING WAYPOINTS; when the
transfer is complete the soft key is re-displayed.
hsb Plus Series Fishfinders
2
, you must set-up the transfer on
hsb
2
hsb instrument overwrites any
2
. While the data is being trans-
hsb
2