Switching The Display On And Off - Raymarine hsb2 PLUS Owner's Handbook Manual

3-2

3.2 Switching the Display On and Off

The factory default power-up mode is full-screen fishfinder. Once you have
used the display unit it powers-up in the last used mode. The following
sections describe the power-up sequence in fishfinder and chart modes, how to
adjust the lighting and color controls, and how to select simulator mode.
➤ To switch the display on in fishfinder mode:
Press and hold the POWER key until the unit beeps. The keys light up and after
a few moments the display shows the fishfinder screen.
ntil unit beeps
Figure 3-1:
You can adjust the display brightness and contrast/colors, as described later in
this chapter.
Setting the Fishfinder as Master/Repeater
You need to set your display as a fishfinder master or repeater. If the display is
connected to a sonar transducer it is a master display. If your display is part of
an integrated system, connected to another fishfinder master it is a repeater
display. Fishfinder functionality is the same on both master and repeater
displays, with the following limitations:
• Automatic Gain cannot be adjusted on the repeater display, but Manual
Gain can be.
• STC cannot be adjusted on the repeater display.
• Depth offset, speed and temperature calibration (see Section 7.4) cannot be
set on the repeater display.
• Frequency can be selected on either master or repeater display, but the
same frequency is used on both displays.
AUTO GCRZFH
FREQUENCY
Switching On in Fishfinder Mode
hsb Plus Series Fishfinders
2
50kHz
SD
0
8
38
45
52
100
ft
ZOOM BTM.LOCK A-SCOPE
D5443-1