Raymarine hsb2 PLUS Owner's Handbook Manual page 36

2-2
Transducer
Compass
Figure 2-2:
Note: If you wish to practice using the display before installation, use the sim-
ulator mode, as described in Chapter 3. For power, connect a 12V or 24V DC
power supply, attaching the red wire via a quick blow fuse (6A for 12V or 4A
for 24V) to positive and the black wire to negative.
If you are connecting your display to other equipment (including another
Plus Series display unit) install then test the fishfinder display and transducer
as described in this chapter. Once the display is operating correctly, you can
connect it to other equipment as described in Section 2.7Integrated Systems
on page 2-18, taking particular care to ensure the correct polarity of the
SeaTalk supply. Section 2.7 describes the
interfaces.
For the Fishfinder to display depth, water temperature and speed, you must
install the Depth/Speed/Temp transducer supplied with your system.
For full functionality of the radar and chartplotter you need to provide position
and heading data.
• Heading data enables the chart to operate in North Up and Course Up
modes. If speed data is also available the MOB function operates.
• Position data is required for full functionality of the chart display.
Series Master Display
2
hsb
NMEA 12/24V Supply
12V Supply
Fishfinder in an Integrated System
hsb Plus Series Fishfinders
2
Series Repeater Display
2
hsb
HSB
SeaTalk
Distribution Panel
12V Supply
, SeaTalk and NMEA
hsb 2
GPS
Junction
Box
hsb
2