Chapter 5: Standard Chart Operations
• Placing a Waypoint
• Selecting a Waypoint
• Displaying Waypoint data
• Editing a Waypoint (symbol, name & position)
• Erasing a Waypoint
• Moving a Waypoint
At the end is a section about using the ST80 Navigator Keypad to select, edit,
and name your waypoints.
Placing a Waypoint
The scenario Place and Goto a Waypoint on page 5-44 provides a simple
example of how to place a waypoint.
➤ To access the place waypoint soft keys, press MARKS:
PLACE WPT
PLACE WPT
MARKS
MARKS
AT CURSOR
AT CURSOR
➤ To place a waypoint at the cursor position or at the vessel position:
PLACE WPT
1. Press either the PLACE WPT AT CURSOR or the PLACE WPT AT VESSEL soft
AT CURSOR
key. The waypoint is added to the waypoint list and tagged using the next
available number.
PLACE WPT
AT VESSEL
The waypoint soft keys are displayed until you move the cursor away from
the waypoint or press CLEAR.
WAYPOINT
You can use the EDIT WAYPOINT soft key to name the waypoint as
described in Editing Waypoints below.
2. Press CLEAR or ENTER to remove the place waypoint soft keys.
➤ To place a waypoint as latitude/longitude using the Waypoint List:
1. Press MARKS, followed by the WAYPOINT LIST soft key. The Waypoint List
MARKS
and associated soft keys are displayed.
WAYPOINT
LIST
PLACE WPT
PLACE WPT
AT VESSEL
AT VESSEL
GOTO
EDIT
WAYPOINT
WAYPOINT
WAYPOINT
LOAD/SAVE
LIST
USER CARD
LIST
D4169-1
ERASE
MOVE
WAYPOINT
WAYPOINT
D4163-1
5-9
D5572-1