The Chartplotter Display - Raymarine hsb2 PLUS Owner's Handbook Manual

Raymarine hsb2 plus radar: user guide
Hide thumbs Also See for hsb2 PLUS:
Table of Contents

Advertisement

1-12

1.3 The Chartplotter Display

The L755RC, L760RC and L1250RC Plus Fishfinders include a Chartplotter.
The chartplotter includes a small-scale world map and detailed navigation
information is displayed when a cartographic chart card is installed. The
details displayed depend on the chart zoom level selected. A plotter mode is
provided to enable route plotting and tracking at large scales even when a chart
card is not installed A typical chartplotter screen is shown in Figure 1-4.
Note: For an L760 Plus or L1250 Plus fishfinder-only unit to have access to
chartplotter functionality, it must be connected to an
plotter device. This is discussed fully in the section Integrated Systems on
page 2-18.
The chartplotter uses position information from a GPS, DGPS, WAAS, or
Loran-C instrument. Once the position fix has been established, your vessel's
position, if on screen, is shown as a boat shape pointing in the direction of the
current heading (or COG if heading data is not available). If no heading or
COG data is available, the vessel is shown as a circle.
The chartplotter screen includes a status bar that displays chart scale, with
either cursor position, range and bearing or, when the cursor is homed to the
vessel (by pressing FIND SHIP), vessel position, Speed Over Ground (SOG),
Course Over Ground (COG) and fix type (VES POS, DIF FIX or SD FIX).
The status bar also indicates if radar/chart overlay is switched on.
Any waypoints you have placed are displayed (unless you turned them off in
Chart Set Up as described in Chapter 7) and the current route is shown.
Information can be viewed on-screen by positioning the cursor over a
waypoint, current route or chart object. The chartplotter screen can also show
additional information, depending on your currently selected options, set up
selections and data available from other equipment.
An example chart display, in its default configuration, with a chart card
installed, is shown in the following illustration.
Several functions are available to control the display as follows:
• Zoom in/out and Pan the Display
• Offset the Chart or Center the Chart around the Vessel
• Overlay Radar Targets onto the Chart Display
• Synchronize the Chart and Radar (if radar data is available)
Operation of these functions is described in Chapter 3.
hsb
Plus Series Fishfinders
2
Plus Series Chart-
hsb
2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

L1250L1250rcL755rcL760L760rcHsb2 plus series

Table of Contents