Figure 11 Login Window
Completing the Getting
Started Wizard
Initial Configuration
Note: If the Login window does not display, verify that you entered the correct IP
address (10.1.1.1) and that the network settings on the computer are
correct. Wait five minutes, then try again. If the Login window still does
not display, contact Quantum Customer Support. (Contact information is
located on the last page of this document.)
Continue with the next section to log on to the system and complete the Getting
Started wizard.
To complete the DXi4000 Getting Started wizard:
1 On the Login window, select Administrator, type password for the password, and
click Login.
The Welcome page displays (see
Note: If a message on the page indicates the DXi is in Limited Mode, wait ten
minutes, and then log on again.
Figure
12).
DXi4000
15