Performing An Inventory - Quantum ACL 4/52 Installation Manual

Performing an Inventory

This feature allows you to perform an inventory of the cartridges
contained in the library. The inventory information is then written to
nonvolatile RAM. To perform this function, use the Inventory sub-
menu as follows:
Press and release the Control Panel STANDBY button and verify
6
that the SDA shows System Off-line .
Press and release the SELECT button to enter the Menu Mode.
7
Verify that the following is displayed in the SDA:
8
M e n u :
C o n f i g u r a t i o n . .
Press the
9
Control , Calibration , System Test and Robot Control menus. Then
verify that the following is displayed in the SDA:
M e n u :
D i a g n o s t i c s . .
Press and release the SELECT button to choose the Diagnostics
10
menu and verify that the following is displayed in the SDA:
M e n u : D i a g n o s t i c s
H o m e A l l
Press the
11
All , Status Actuator , Status Sensor and Move Actuator sub-menus.
Then verify that the following is displayed in the SDA:
M e n u : D i a g n o s t i c s
I n v e n t o r y
With Inventory displayed on Line #2, press and release the SELECT
12
button.
Note: With a full library, the inventory process will take less than three
minutes if all of the cartridges are properly bar code labeled. The
actual inventory time can take longer if the library is not completely
full or if any of the cartridges are not properly labeled. When the
library is full of unlabeled cartridges the inventory process will take
over twenty-seven minutes to complete.
ACL 4/52 Facilities Planning and Installation Guide
Appendix B Supplemental Installation Procedures
button five (5) times to bypass the Configuration , Drive
button five (5) times to bypass the Home All , Selftest
Performing an Inventory
2
41