Table of Contents
Advertisement
Appendix B Supplemental Installation Procedures
Enabling/Disabling the Auto-Load Feature
36
Enabling/Disabling the Auto-Load
Feature
This feature of the ACL 4/52 library enables the operator to load
cartridges into the fixed storage array (FSA) without any intervention
from the host controller. When this feature is Enabled , the library will
automatically find bins in the FSA for cartridges that are placed in the
load port. If no bin locations are available in the FSA, the cartridges
will be left in the load port bin and an error message will be displayed
on the control panel SDA.
The default configuration for this feature is Disabled. To enable this
feature on the library, perform the following procedures:
Press and release the Control Panel STANDBY button and verify
1
that the SDA shows System Off-line .
Press and release the SELECT button to enter the Menu Mode.
2
Verify that the following is displayed in the SDA:
3
M e n u :
C o n f i g u r a t i o n . .
Press and release the SELECT button to choose the Configuration
4
menu.
Verify that the following is displayed in the SDA:
5
M e n u : C o n f i g u r a t i
I n q u i r y
Press the
6
Address , Power-Up State , Num of Drives , Auto Clean and Retries
menus. Then verify that the following is displayed in the SDA:
M e n u : C o n f i g u r a t i
A u t o L o a d . .
With Auto Load displayed on Line #2 of the SDA, press and release
7
the SELECT button and verify that the following is displayed in
the SDA:
M e n u : A u t o L o a d
D i s a b l e d
Note: " Disabled" is the default state for the auto-load option. If you want to
change this feature to "Enabled," proceed to Step 8. Otherwise, exit
the menu mode.
ACL 4/52 Facilities Planning and Installation Guide
button six (6) times to bypass the Inquiry , SCSI
2
Advertisement
Table of Contents
